Clean up voice audio with Studio Sound

Studio Sound separates your voice from the room it was recorded in: fans, traffic, echo, microphone hiss. It runs on your Mac, and it makes a cleaned copy rather than changing your recording, so you can always go back.

Apply it

1. Choose Enhance > Studio Sound…, or open the Enhance rail and press Studio Sound.
2. Choose a Restoration strength:
   • Natural keeps more of the room's character.
   • Balanced is a clean, natural default.
   • Strong is for fans, traffic and difficult rooms.
3. Leave Voice polish on to tighten low rumble and add a little presence to speech, or turn it off.
4. Press Generate Studio Sound. A long recording can take several minutes; the sheet shows progress, and Stop cancels.
5. Compare: press Original and Studio Sound to hear each.
6. Press Use enhanced version, or Try different settings to throw the result away and start again.

Studio Sound works on the whole main recording, every take of it, with the same settings. It works on audio-only projects too.

The strength and voice polish the sheet opens with come from Settings > Audio, under Default strength and Voice polish by default.

What it is good at

It is built for speech. Music, and heavily mixed audio from your Mac, can come out sounding unnatural - which is one reason Rooster always makes a separate copy instead of overwriting anything.

Change or remove it

Select the main recording and open Adjust. While an effect is applied, an Effects band lists it, with a button to adjust it - which reopens the sheet - and a bin to remove it. Removing it puts back the version underneath - your original, unless another effect was applied first. If another effect was rendered on top of Studio Sound afterwards, remove that one first; Rooster says so.

The cleaned copy is kept in Rooster's own folder, as a rendered clip. See Where Rooster saves recordings and exports.